READ_WORKSPACES

This command is used in both the POLY and GES (GIBBS) modules.

The POLY3 and GIBBS workspaces and the calculated results from the MAP and STEP commands can be READ from a file where they are saved with SAVE_WORKSPACES. Such a *.POLY3 file is not printable.

Syntax	read_workspaces
Options	`File name` is the name of a saved POLY3-file where the POLY3 and GIBBS workspaces shall be read from must be specified. You do not need to type the extension if it is the default .POLY3, otherwise type the whole POLY-file name. A reminder that Linux and Mac are case sensitive; when applicable ensure you enter file extensions with capital letters. A window opens so that the path (in the Look in field) and File name can be specified. The Files of type (i.e. POLY3) cannot be changed. Click Open to open the POLY3 and GIBBS workspaces from the saved .POLY3 file.
	When reading back an original POLY3 workspace that has already been saved as an *.POLY3 file in the current Thermo‑Calc (Console Mode) run or had been read from an existing POLY3 file under the current work area, while some additional changes in the settings may be made but do not need to be kept in further steps in the current Thermo‑Calc (Console Mode) run or any diagram is plotted in the POST module, you can type `READ,,` or `READ_WORKSPACE ,,`

Syntax

read_workspaces

Options

File name is the name of a saved POLY3-file where the POLY3 and GIBBS workspaces shall be read from must be specified. You do not need to type the extension if it is the default *.POLY3, otherwise type the whole POLY-file name.

A reminder that Linux and Mac are case sensitive; when applicable ensure you enter file extensions with capital letters.

A window opens so that the path (in the Look in field) and File name can be specified. The Files of type (i.e. POLY3) cannot be changed. Click Open to open the POLY3 and GIBBS workspaces from the saved *.POLY3 file.

When reading back an original POLY3 workspace that has already been saved as an *.POLY3 file in the current Thermo‑Calc (Console Mode) run or had been read from an existing POLY3 file under the current work area, while some additional changes in the settings may be made but do not need to be kept in further steps in the current Thermo‑Calc (Console Mode) run or any diagram is plotted in the POST module, you can type READ,, or READ_WORKSPACE ,,